Six-axis arm

ARC Arm M8

A six-axis arm with tooling cut to your part, retrofitted into a running line between shifts.

Up to 35 kg

Payload

5–200 mm

Grip range

< 0.9 s

Cycle time

±0.02 mm

Accuracy

Six-axis industrial robot arm carrying a vacuum end-effector inside an aluminium-framed cell

On this page

Overview

A six-axis arm supplied with its tooling already cut to your part, wired, and proven on the bench before it reaches the floor. It is the quickest way to put a robot on a line that is already running.

Most of these go in as retrofits, between shifts, on equipment that cannot stop for a week.

The arm itself is a standard six-axis machine. What we add is the tooling, the wiring, the safety case, and the proof that all three work together before it arrives.

Specification

The arm carries up to 35 kg including tooling, with grip range from 5 to 200 mm on the supplied end-effector. A pick and place cycle completes in under 0.9 seconds, and repeatability holds to ±0.02 mm.

Reach and mounting orientation are chosen against your station rather than the other way round.

Proven before delivery

The arm runs your cycle on our bench for a full production shift, with the tooling that will ship with it. The figures on the handover sheet come from that run, and the log goes in the crate.

Integration

We map your interface before anything is built: signals, safety circuits, addresses and the way your engineers name them. The arm and its tooling are wired and run against that map here, on our bench.

The retrofit is planned around a maintenance window, with the point of no return marked on it and the old setup boxed until the new one has run a full week.

Safety is the part that takes longest, not the robot. The assessment covers the altered area rather than the arm alone, and it is written before the window opens.